DP fence progress

The fence is made up of 2 pieces of 3/4 inch plywood and 1 piece of 1/2 inch, all face glued. This sandwich is wrapped with 3/4 inch red oak strips on 3 edges. I'm not going to worry about the edge that will always be down. I applied white laminate to the front face and drilled two holes in the top oak piece for the "through bolts" that sit in the T-track of the DP table and allow the fence to be clamped down.

Tonight I can trim the laminate with a chamfering router bit.

The last thing is to install some T-track on the top. Some people put T-track into the face too, and I am considering that.